Click Here to Visit our Original Site
  • Home
  • How to Order
  • Contact
  • Site map
  • Privacy
719-676-3928 Live Chat! Email Us

ESD Carpeting with permanent static control properties

Powerful Performance, Outstanding Value!

OUR PRODUCTS

ESD Concrete Sealer

ESD Vinyl Tile

ESD Carpet Tile

ESD Sheet Floors

ESD Epoxy Floor Paint

ESD Wax, ETC

ESD Matting

ESD Constant Monitors

Wrist & Heel Straps

ESD Ionizers

ESD Test Equipment

ESD Smocks

PURCHASE ON LINE

Shopping Cart!

 

 

VIEW THIS SITE IN

Spanish

 

0
[Back] Home / ESD Wax / ElectraThane / MSDS Sheet

EltraThane Material Safety Data Sheet

Eletrathane flooring sealant for use with electraguard

MSDS Sheet

SECTION I(Identity) - PN: E-Clean, Static Dissipative ESD Floor Cleaning Solution
Hazardous: No
Health: 1 
Flammability: 0
Reactivity: 0
Personal Protection: B
Note
Most Hazardous: 4
Prepared
Prepared By: J Carlson
Date: 12/06/06
Emergency Contact Details
Emergency Contact: 1-800-255-3924 or Poison Center
Tel.Information: (719) 676 3928
Address: United Static Control Products.com Inc
POB 19252,
4878 Lakeview Cir
Colorado City, CO,
81019,USA
 
SECTION II - HAZARDOUS INGREDIENTS
Hazardous Components PEL(ppm) TWA(ppm) STEL(ppm) Other Limits %(Opt) CAS Reg#  
- - - - - - -  
Not a hazardous mixture, as defined in 29 CFR 1910,1200 and M.G.L. c. 111F
Contains: Glycol Ethers* <6
*Chemical category subject to reporting requirements of SCT.313 of TITLE III.
 
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Appearance and Odor Translucent White Liquid
Auto Ignition Temp. N.A
Boiling point 218 F
Decomposition Temperature N.A
Evaporation Rate(Butyl Acetate=1) 0.36
Melting Point N.A
pH 8.6 +/-0.4
Specific Gravity(Water=1) 1.02
Solubility in water Complete
Vapor Pressure (mm Hg) 18
Vapor Density (air=1) 1.1
Viscosity (CPS) 15
 
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point None
Extinguishing media N.A
Fire Fighting Procedure N.A
Fire and Explosion Hazards N.A
Flammable Limits LEL - N.A.,UEL - N.A.
 
SECTION V - REACTIVITY DATA
Stability Stable
Conditions to Avoid Freezing, Extreme Heat
Incompatibility Acids, Oxidizers
Hazardous Decomposition or Byproduct Thermal Decomposition may yeild CarbonMonoxide
Hazardous Polymerization Will not occur
Conditions to Avoid N.A
The information herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of these data or results to be obtained from use thereof. Essentially similar to OSHA form # 174
 
SECTION VI - HEALTH HAZARD DATA
Routes of Entry Inhalation Skin Ingestion  
  No No No
Acute Causes Eye and Skin Irritation
Chronic Redness of Skin
Carcinogenicity No
NTP N.A
IARC Monographs N.A
OSHA Regulated No
Signs and Symptoms of Exposure Irritation, Redness of Skin, Eyes
Medical Conditions Aggravated N.A
Emergency and First Aid Procedures Wash contact areas with soap and water. INGESTION:Drink milk, water, fruit juice, induce vomiting with oil of ipecac, get medical attention.
 
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be Taken in Case Material is Released or Spilled
1. Dike, collect material into watertight container, rinse surface with clean water
Waste Disposal Method
1. Use sanitary landfill disposal, (not a hazardous waste) according to federal, state and local regulations. (RCRA, Subtitle D.)
Precautions to be Taken in Handling and Storage
1. Do not mix with other chemicals.
2. Store away from heat.
3. Keep from Freezing.
Other Precautions
1. Keep away from children.
 
SECTION VIII - CONTROL MEASURES
Respiratory Protection
Not required with normal use.
Ventilation
Local Exhaust - N.A.
Mechanical - N.A.
Special - N.A
Other - Assure fresh air ciculation.
Protective Gloves
Recommended: Rubber,Plastic
Eye Protection
Recommended: Safety Glasses, Goggles
Other Protection
N.A
Work/Hygienic Practices
1. Do not eat, drink next to material.
2. Wash hands/face after work.
 
SECTION IX - TRANSPORTATION 49 CFR
Unit Cont.
55,30,5,1 GAL. Plastic Cont
OSHA
Not Regulated
DOT
Not Regulated
UN
Not Regulated
Report Qty.(Lbs)
N.A
Labels
No
Vendor assumes no responsibility for injury to vendee or third person proximately caused if reasonable safety procedures are not adhered to as stipulated in the data sheet. Additionally, vendor assumes no responsibility for injury to vendee or third persons proximately caused by abnormal use of the material even if reasonable safety procedures are followed. Further more, vendee assumes the risk in use of the material.
  • ESD Flooring
  • |
  • Mats
  • |
  • ESD Floor Care Products
  • |
  • ESD Ionizers
  • |
  • Ultrastat2000.com

new esd flooring products for 04/05/10

TERMS CONDITIONS AND YOUR PRIVACY 
This site is protected by copyright and trademark laws under US and International law.

United Static Control Products Inc
 

4878 Lake View Circle

Colorado City, CO 81019

United States of America