Electrastrip ESD Floor Wax Stripper Material Safety Data Sheet

ElectraShine: This innovative esd floor spray buff is formulated as a companion product for ElectraGlaze floor finish but works great with virtually any esd floor wax. Easy to use, consistent results and ULTIMATE shine ElectraShine extends the static control floor finish properties while restoring and enhancing the gloss desirable in many of today's high tech environments. ElectraShine is ideal for use with either propane or electric high speed polishing equipment (1200 rpm or higher) providing coolant properties that help reduce heat related stress of the esd flooring substrate / adhesive.

MSDS Sheet

SECTION I(Identity) - PN: E-Clean, Static Dissipative ESD Floor Cleaning Solution
Hazardous:	Yes
Health:	2
Flammability:	0
Reactivity:	0
Personal Protection:	B
Note
Most Hazardous:	4
Prepared
Prepared By:	A. Vadasz
Date:	03/28/03
Emergency Contact Details
Emergency Contact:	1-800-255-3924 or Poison Center
Tel.Information:	(719) 676 3928
Address:	United Static Control Products.com Inc POB 19252, 4878 Lakeview Cir Colorado City, CO, 81019,USA


SECTION II - HAZARDOUS INGREDIENTS
Hazardous Components	PEL(ppm)	TWA(ppm)	STEL(ppm)	Other Limits	%(Opt)	CAS Reg#
*2-Butoxyethanol	50	25	-	-	<30	111-76-2
Ethanolamine	3	3	6	-	<20	141-43-5
Not a hazardous mixture, as defined in 29 CFR 1910,1200 and M.G.L. c. 111F
* Listed chemical subject to reporting requirement of SCT.313 of TITLE III.

SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Appearance and Odor	Thin, Yellow Liquid,Detergent Odor
Auto Ignition Temp.	N.A
Boiling point	215 F
Decomposition Temperature	N.A
Evaporation Rate(Butyl Acetate=1)	0.25
Melting Point	N.A
pH	12.2 +/- 5
Specific Gravity(Water=1)	0.985
Solubility in water	Complete
Vapor Pressure (mm Hg)	16.0
Vapor Density (air=1)	1.2
Viscosity (CPS)	12.5

SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point	Above 200 F TCC
Extinguishing media	Water Spray
Fire Fighting Procedure	Cool Containers with water
Fire and Explosion Hazards	Closed containers may burst when exposed to extreme heat. Isolate from heat,sparks and open flame.
Flammable Limits	LEL - N.A.,UEL - N.A.

SECTION V - REACTIVITY DATA
Stability	Stable
Conditions to Avoid	N.A
Incompatibility	Acids,Strong Oxidizers
Hazardous Decomposition or Byproduct	Thermal Decomposition may yeild CarbonMonoxide
Hazardous Polymerization	Will not occur
Conditions to Avoid	N.A
Medical Conditions Aggravated	Sensitized skin, Renal deficiency

Emergency and First Aid Procedures
1. Wash contact areas with plenty of water:15 Minutes.
2. Ingestion: Give Milk,Water or Citrus Juice, Induce Vomiting(with Ipec).
3. Move subject to fresh Air.
3. Call Physician Immediately.

SECTION VI - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be Taken in Case Material is Released or Spilled
1. Dike and collect material into plastic container. Water rinse and drain. Flush small amounts.(Biodegradable)
Waste Disposal Method
1. Use sanitary landfill disposal. (Not a hazardous waste)Follow state and local regulations(RCRA;SUBTITLE D)
Precautions to be Taken in Handling and Storage
1. Do not mix with other chemicals.
2. Avoid prolonged contact.
3. Keep from Freezing and excessive heat.
Other Precautions
1. Store in secure area.
2. Avoid food contamination.
3. Avoid prolonged inhalation of vapours.
3. Keep out of reach of children.

SECTION VII - CONTROL MEASURES
Respiratory Protection
Not required with normal use in well ventilated area.
Ventilation
Local Exhaust - Recommended.
Mechanical - Required: Exchange every 10-15 minutes
Special - N.A
Other - Assure fresh air ciculation.
Protective Gloves
Required: Rubber,Plastic
Eye Protection
Required: Safety Glasses, Goggles
Other Protection
Recommended: Rubber or plastic apron,shower,eye wash facility.
Work/Hygienic Practices
1. Do not eat, drink next to material.
2. Wash hands/face after work.

SECTION VIII - TRANSPORTATION 49 CFR
Unit Cont.
55,30,5,1 GAL. Plastic Cont
OSHA
Not Regulated
DOT
Not Regulated
UN
Not Regulated
Report Qty.(Lbs)
N.A
Labels
UN-Corrosive
Vendor assumes no responsibility for injury to vendee or third person proximately caused if reasonable safety procedures are not adhered to as stipulated in the data sheet. Additionally, vendor assumes no responsibility for injury to vendee or third persons proximately caused by abnormal use of the material even if reasonable safety procedures are followed. Further more, vendee assumes the risk in use of the material.

ESD Carpeting with permanent static control properties

Powerful Performance, Outstanding Value!

OUR PRODUCTS

ESD Concrete Sealer

ESD Vinyl Tile

ESD Carpet Tile

ESD Sheet Floors

ESD Epoxy Floor Paint

ESD Wax, ETC

ESD Matting

ESD Constant Monitors

Wrist & Heel Straps

ESD Ionizers

ESD Test Equipment

ESD Smocks

PURCHASE ON LINE

Shopping Cart!

VIEW THIS SITE IN

Spanish

Electrastrip ESD Floor Wax Stripper Material Safety Data Sheet

MSDS Sheet